Redian新闻
>
请问有谁有自己关游泳池的经验吗?
avatar
g*8
2
RD 10月初
今天message 通知
然后上网查
New Card Is Being Produced
On February 23, 2016, we ordered your new card for Receipt Number XXXXX, and
will mail it to the address you gave us. If you move, go to www.uscis.gov/
addresschange to give us your new mailing address.
这是绿了是嘛???
现在是不是可以不用担心被雷了
avatar
b*h
3
有几个问题想请教一下。
谢谢!
avatar
c*g
4
这个有人收么?
avatar
m*u
5
gxgx

and

【在 g**********8 的大作中提到】
: RD 10月初
: 今天message 通知
: 然后上网查
: New Card Is Being Produced
: On February 23, 2016, we ordered your new card for Receipt Number XXXXX, and
: will mail it to the address you gave us. If you move, go to www.uscis.gov/
: addresschange to give us your new mailing address.
: 这是绿了是嘛???
: 现在是不是可以不用担心被雷了

avatar
F*Q
6

I've done it myself for the past 6 years, let me know if I can be any help.

【在 b*********h 的大作中提到】
: 有几个问题想请教一下。
: 谢谢!

avatar
t*1
7
Congrats!!!
avatar
b*h
8
谢谢,给您私信了
avatar
u*r
9
恭喜!
avatar
n*s
10
贴在这里大家都可以学习。
在佛罗里达,没弄过。
avatar
l*h
11
Congrats!
avatar
F*Q
12

ok, here are my closing procedures. I live in MA, I close my poor mostly at
the end of Sep, although it could be sooner. My procedures apply to my in-
ground vinyl liner pool. I assume other types of pools are similar.
IMPORTANT: pool repairs are expensive! you have to be very careful, don't
rush, if you don't understand the steps, don't do it. you may ruin your pool
permanently!
In summary:
1. add 4 gal shock and 16 oz algeacide, and circulate
2. drain water to a few inches below the returning sprouts
3. cover your pool
4. disconnect and drain all equipment (pump, filter, feeder etc)
5. add antifreeze to the in-ground lines, 1 gal per line
---------------------------------------
** Step 0: Preparation
you need to reserve a weekend for closing your pool. I did most closing all
by myself, but this year, my dad helped me putting on the cover.
you need to buy the below supplies for pool closing:
1. a case (4x 1gal bottles) liquid shock; my pool is 32x16, this is what I
needed, if you have a larger pool, buy more. 1 case here costs about $16
2. a bottle of algeacide (32oz), cost about $25
3. 2 bottles (2x 1 gal) pool antifreeze, $5 per bottle
---------------------------------------
** Step 1: add chemicals and circulate
- balance the water, make sure everything is in normal ranges
- if possible, vacuum the pool to make the bottom clean
- when there is no direct sunlight, say after 4:00PM, pour 4x liquid shock
into the pool
- add half bottle (16 oz) of algeacide
- keep the pump running for at least an hour or two
- while the water is circulating, use brushes to brush the walls, and the
bottom, use net to get all leaves out.
---------------------------------------
** Step 2: Draining the pool water
- once the pool is clean and the chemicals are well mixed, you may start
draining the pool
- turn off your pump, backwash your filter (if sand filter) or clean the
filter (DE filter, like mine)
- turn the filter's drain valve to ON, let all water drained from the filter
- set the chlorine feeder to OFF
- turn on the pump, let the water drain from the filter drain
- drain the water until 3-4 in below the returning sprouts (not the skimmer!
).
- starting this year, I add a plug at each of the returning sprout to
prevent water getting into the line during winter.
when the water level drops to about 1cm above the skimmer opening, your pump
may lose prime because air can get into the pump. I stopped my pump at this
point, and then use two short segments of hose (1m each, from my pool
vacuum). one end of the hose connect to the skimmer drain, the other end is
put inside the pool. this allows me to drain below the skimmer level.
be very careful! don't let the open-end of the hose drift! it can easily
suck on your liner and, if leave for long, can damage your liner.
my trick is to tie a knot using the hose, this way, it won't turn back to
the pool wall. a picture of the knot is attached.
if you don't feel comfortable doing this. you can buy a submersible pump
http://www.homedepot.com/b/Plumbing-Pumps/N-5yc1vZbqlb
draining the pool can take half to 1 hour, depends on your pump set up. don'
t drain too much water, you want to keep your pool pressurized.
---------------------------------------
** Step 3: Putting on safety cover
- remove all ladders
- put on the safety cover following the instructions,
- make sure all springs are loaded to its desired range, if too tight or too
lose, adjust the straps
---------------------------------------
** Step 4: Dissemble your pump, filter and chlorine feeder
- if those are outdoor, you need to disconnect them
- drain all the water from each one of them - filter, pump, feeder etc
- for my DE filter, I will open it and wash the interior with a garden hose
- leave them outside to dry for a day or two before moving them to the
garage or a shed
---------------------------------------
** Step 5: Add antifreeze to the pool lines
- once you remove all the equipment, you should see two pipes: a pipe
connects to the skimmer, and a pipe connects to the returning jet
- if you have a shop vac, blow the water out, or suck the water out as much
as you can
- add 1 gal pool antifreeze for each line
You are done!
during winter months, you may check water level a few times. if you have too
much rain, the water may raise above the returning jet, you may have to
drain again. Because I plugged the returning jet this year, I hope the
antifreeze won't get diluted even the water level goes above the sprout
openings.
the nearby pool company owner told me to pour another 2gal shock after
thanksgiving for best results, but I did not always follow.
if you don't have a good cover, go get one! it is important to have a good
cover. I used a tarp in the first year, and it creates lots of damages to my
pool :( I regretted it very much.

【在 n***s 的大作中提到】
: 贴在这里大家都可以学习。
: 在佛罗里达,没弄过。

avatar
o*i
13
恭喜 总算来了个NSC的
avatar
F*Q
14
forgot to attach, here is my trick to use the circulation pump to drain the
pool below the skimmer line. you can also secure the knot by a wire.
avatar
s*c
15
CONG!
avatar
n*s
16
向版主推荐作为保留文章。
北佛罗里达不用关池。我冬天也继续加药。泵开得短点。

at
pool

【在 F***Q 的大作中提到】
: forgot to attach, here is my trick to use the circulation pump to drain the
: pool below the skimmer line. you can also secure the knot by a wire.

avatar
m*u
17
我也这么觉得 干儿子的心操完了,总算轮到亲儿子了

【在 o**i 的大作中提到】
: 恭喜 总算来了个NSC的
avatar
H*r
18
re
avatar
j*6
19
恭喜恭喜
avatar
o*h
20
Cong!
avatar
p*m
21
恭喜恭喜
avatar
o*g
22
gxgx
avatar
w*w
23
congratz!
avatar
o*i
24
这话糙理儿不糙

【在 m*****u 的大作中提到】
: 我也这么觉得 干儿子的心操完了,总算轮到亲儿子了
avatar
p*x
25
恭喜
[在 gududeren818 (gududeren818) 的大作中提到:]
:RD 10月初

:...........
avatar
v*n
26
cong
avatar
m*y
27
con
avatar
w*u
28
恭喜恭喜!同是10月的NSC case,希望自己早绿。
avatar
d*n
29
恭喜! 沾喜气:)

and

【在 g**********8 的大作中提到】
: RD 10月初
: 今天message 通知
: 然后上网查
: New Card Is Being Produced
: On February 23, 2016, we ordered your new card for Receipt Number XXXXX, and
: will mail it to the address you gave us. If you move, go to www.uscis.gov/
: addresschange to give us your new mailing address.
: 这是绿了是嘛???
: 现在是不是可以不用担心被雷了

avatar
g*e
30
gxgx
avatar
z*g
31
大大的恭喜
avatar
z*0
32
恭喜,沾点喜气
avatar
m*6
33
恭喜,
10底的啥时候啊,苦等
avatar
t*r
34
cong
avatar
j*a
35
恭喜恭喜!
avatar
v*i
36
恭喜恭喜!同是10月的NSC case,沾沾喜气!!!!
avatar
R*d
37
cong

and

【在 g**********8 的大作中提到】
: RD 10月初
: 今天message 通知
: 然后上网查
: New Card Is Being Produced
: On February 23, 2016, we ordered your new card for Receipt Number XXXXX, and
: will mail it to the address you gave us. If you move, go to www.uscis.gov/
: addresschange to give us your new mailing address.
: 这是绿了是嘛???
: 现在是不是可以不用担心被雷了

avatar
R*d
38
cong
avatar
m*q
39
CONG
avatar
s*n
40
big cong
avatar
a*q
41
cong
avatar
u*0
42
cong
相关阅读
logo
联系我们隐私协议©2024 redian.news
Redian新闻
Redian.news刊载任何文章,不代表同意其说法或描述,仅为提供更多信息,也不构成任何建议。文章信息的合法性及真实性由其作者负责,与Redian.news及其运营公司无关。欢迎投稿,如发现稿件侵权,或作者不愿在本网发表文章,请版权拥有者通知本网处理。