一地叉的1.24 firmware upgrade 悄悄地来了# PhotoGear - 摄影器材
G*g
1 楼
http://www.usa.canon.com/cusa/consumer/products/cameras/slr_cam
Firmware Version 1.2.4 incorporates the following improvements and fixes:
Improves the speed of the camera’s acquisition of focus when using a Canon
Speedlite’s AF-assist beam.
Reduces the time it takes to display the metering result on the LCD or
Viewfinder when the meter has been activated.
Fixes a phenomenon in which a “Caution 02” message is unnecessarily
recorded in the camera status log.
Fixes a phenomenon in which continuous shooting pauses when using a Canon
Speedlite.
Fixes a phenomenon, when the Canon GP-E1 is attached, in which the GPS
device settings are reset to default settings when the camera has been
powered off.
Note: *This phenomenon occurs only with firmware Ver. 1.2.1. After changing
the GPS device settings, please be sure to power off the camera before
removing the battery. This will ensure that the camera’s GPS device
settings will be saved.
Firmware Version 1.2.4 is for cameras with firmware version 1.2.1 or earlier
. If your camera’s firmware is already Version 1.2.4, it is not necessary
to update the firmware. When updating your camera’s firmware, please review
the instructions thoroughly before you update the firmware.
The firmware update takes approximately seven minutes.
Firmware Version 1.2.4 incorporates the following improvements and fixes:
Improves the speed of the camera’s acquisition of focus when using a Canon
Speedlite’s AF-assist beam.
Reduces the time it takes to display the metering result on the LCD or
Viewfinder when the meter has been activated.
Fixes a phenomenon in which a “Caution 02” message is unnecessarily
recorded in the camera status log.
Fixes a phenomenon in which continuous shooting pauses when using a Canon
Speedlite.
Fixes a phenomenon, when the Canon GP-E1 is attached, in which the GPS
device settings are reset to default settings when the camera has been
powered off.
Note: *This phenomenon occurs only with firmware Ver. 1.2.1. After changing
the GPS device settings, please be sure to power off the camera before
removing the battery. This will ensure that the camera’s GPS device
settings will be saved.
Firmware Version 1.2.4 is for cameras with firmware version 1.2.1 or earlier
. If your camera’s firmware is already Version 1.2.4, it is not necessary
to update the firmware. When updating your camera’s firmware, please review
the instructions thoroughly before you update the firmware.
The firmware update takes approximately seven minutes.